manufacturing

Henry talks – furniture assembly

October 16, 2012
Thumbnail image for Henry talks – furniture assembly

In the latest of his blogs, Henry, great-grandson of ercol’s founder talks about his time in the assembly shop during his factory induction: Continuing my route through the factory I followed the cramped and sanded parts as they left the machine shop and headed towards the machined part stores. These stores bisect the factory, on […]

Read the full article →

Henry Talks – cramping

August 15, 2012
Thumbnail image for Henry Talks – cramping

Previously Henry took us through the timber machining process – now he moves onto cramping…..The machined parts will go through the sanding department before heading to either the cramping department – if the parts need to be made into a sub-assembly – before going to the stores, or straight into the machined part stores to […]

Read the full article →

Henry talks – machine bending

July 11, 2012
Thumbnail image for Henry talks – machine bending

In my last post I talked about hand bending, well now for the machine bending… Nearly all of the bends in the dining chairs will be done by a machine, which you can see in the video below.  The type of bend required in the bow means that up to 10 can be placed in […]

Read the full article →

Henry talks – steam bending – by hand

June 29, 2012
Thumbnail image for Henry talks – steam bending – by hand

In 1945 my great grandfather, Lucian Ercolani, the founder of ercol, had finally developed a way in which the classic Windsor chair could be mass produced. Integral to that process was our unique way of steam bending the back bows. Windsor chairs have been made in the High Wycombe area since the 16th century but […]

Read the full article →

Henry talks – dimension parts

June 6, 2012
Thumbnail image for Henry talks – dimension parts

Every piece of timber in the factory will be sourced from one of two sawmills which we use. One in the US that supplies us with all our oak and elm  and one based in Northern Italy which supplies us with beech and ash.  I started off in the Dim (dimensional) part stores as this […]

Read the full article →

Henry talks – an introduction

June 1, 2012
Thumbnail image for Henry talks – an introduction

On the 5th of September 2011 we welcomed Henry Tadros, the great-grandson of ercol’s founder Lucian Ercolani, as he joined the company.  We asked Henry to tell us his experiences so far… I started working at Ercol last September. Over the next 9 months I would be able to have an indepth induction into the […]

Read the full article →

John Bercow nominates ercol

November 15, 2011
Thumbnail image for John Bercow nominates ercol

MP for Buckingham and Speaker of the House of Commons, John Bercow, visited ercol on Friday 11th November.  He spent several hours having the full tour of the works, seeing all the stages involved in making a piece of ercol furniture – from machining, timber bending and

Read the full article →

Ryecotewood tour

October 25, 2011
Thumbnail image for Ryecotewood tour

Students from the National School of Furniture, Oxford Rycotewood Furniture Centre, paid a visit to the ercol factory and showroom last week.  The students are in their second year of a BA in Furniture Design and Make.   The students were shown how ercol creates furniture – from the process of design, through all the […]

Read the full article →